Two way angle valves produced by Chinese faucet factories are mainly made of brass and stainless steel. The dual-port design of this angle valve allows connecting two outlet devices from one inlet, making it ideal for installation in places where water flow needs to be diverted, such as under kitchen sinks or bathroom washbasins. This article will detail how to properly install a two way angle valve to ensure its proper operation and long-term use.
1. Preparation
Before installing the two way angle valve, it is essential to measure the diameter of the water supply pipe and the device interface to ensure they match. Typically, the diameter of the water supply pipe is 1/2 inch or 3/4 inch, while the device interface may vary. Therefore, selecting the appropriate angle valve model is crucial.
2. Installation Steps
Step 1: Turn Off the Water Supply
Before starting the installation, make sure to turn off the water supply to prevent water splashing and accidents.
Step 2: Clean the Interface
Use a clean cloth to clean the water supply pipe and device interface, ensuring there are no impurities or dirt that could affect the sealing effect.
Step 3: Wrap the Seal Tape
Wrap the seal tape around the threaded part of the angle valve, usually 3-5 turns in a clockwise direction. The seal tape prevents leaks and ensures a tight seal between the angle valve and the water supply pipe.
Step 4: Install the Angle Valve
Align the inlet of the angle valve with the water supply pipe and rotate the angle valve clockwise until it is tight. Use a wrench to tighten it appropriately, but do not over-tighten to avoid damaging the threads.
Step 5: Connect the Outlet Devices
Connect the two outlet devices to the two outlets of the angle valve, also using seal tape on the threaded parts to ensure a tight seal at the connections.
Step 6: Check for Leaks
Turn on the water supply and check for any leaks at the angle valve and connections. If there are leaks, re-tighten or replace the seal tape.
3. Precautions
- Always turn off the water supply before installation to ensure safety.
- Use appropriate tools to avoid damaging the angle valve and water supply pipe.
- Regularly inspect the angle valve and connections to ensure there are no leaks.
