The shower set system bathroom concealed rain bath is an integrated concealed shower solution carefully crafted by Chinese faucet factories. Specifically designed for modern bathrooms, it offers a luxurious rain shower experience. Made of high-quality brass or stainless steel, some high-end models are equipped with intelligent thermostatic technology and multi-mode water flow adjustment functions. It is widely applicable to bathrooms in high-end residential buildings, villas, and hotels. Here is a detailed installation guide for it.
(I) Precautions Before Product Installation
(II) Required Installation Tools
(III) Preparation Steps Before Installation
(IV) Standard Installation Process
- Install the concealed thermostatic mixing valve: Use an electric drill to drill holes at the marked positions, embed the embedded box of the mixing valve into the wall, and ensure that the embedded box is horizontal and firm. Connect the cold and hot water pipes, paying attention to distinguishing the cold and hot water interfaces. Generally, it is hot on the left and cold on the right. Wrap PTFE tape when connecting to prevent water leakage.
- Install the water outlet control panel: Drill holes at the corresponding marked positions, fix the base of the control panel, connect the control lines to the mixing valve, and then install the outer shell of the control panel. Ensure that the panel is installed flat and the buttons operate flexibly.
- Install the ultra-thin overhead shower: Drill holes at the corresponding positions on the ceiling, install the overhead shower bracket, fix the overhead shower on the bracket, and adjust the angle and position to ensure that the water evenly covers the shower area.
- Install the multi-functional handheld shower: Install the fixing base of the handheld shower on the wall at an appropriate height, connect the hose of the handheld shower to the mixing valve, check whether the connection is firm, and whether the handheld shower can be used normally.
(V) Usage Testing and Inspection Key Points
(VI) Common Installation Problems and Solutions
1.Water leakage problem: If there is water leakage at the connection, it may be due to insufficient wrapping of PTFE tape or loose joints. You can re-wrap the PTFE tape and tighten the joints.
2.Unsmooth water flow: It may be that there are impurities blocking the pipeline. You can remove the showerhead for cleaning, or check whether the water valve at home is fully opened.
3.Abnormal water temperature adjustment: Check whether the settings of the thermostatic mixing valve are correct. If the problem persists, it may be a fault with the thermostatic cartridge, and you need to contact a professional for repair or replacement.
