(1) Pre-installation Notes
Before installing brass concealed shower set, verify:
- Wall structure must be solid/reinforced (thickness≥12cm)
- Maintain strict 15cm center-to-center hot-cold pipe distance
- Reserve 2-3cm extra depth beyond product thickness for maintenance
- Chinese faucet factory recommends professional plumber installation
(2) Required Tools
- Basic: Spirit level, rotary hammer (6-10mm bits), wrench set
- Measuring: Laser distance meter, angle gauge
- Sealing: PTFE tape (premium thickness recommended), waterproof silicone
- Special: Manufacturer’s template (included)
(3) Preparation Steps
- Check completeness against packing list
- Shut off water supply and drain pipes
- Mark centerline at 110-120cm height using laser level
- Acclimate product to installation environment 48 hours prior
(4) Standard Installation
- Embedding phase:
- Drill holes using template (tolerance≤1mm)
- Secure mounting box with expansion bolts
- Connect pipes (apply 15+ PTFE tape loops)
- Main unit installation:
- Install mixer valve following flow direction marks
- Tighten fixing screws after leveling
- Attach temperature knob (leave 2-3mm clearance)
- Sealing phase:
- Fill with lightweight cement after testing (keep access port)
- Install cover plate after 24-hour curing
(5) Testing Protocol
- Pressure test:
- Gradually pressurize to 0.6MPa for 30 minutes
- Inspect all joints (especially valve base)
- Functional test:
- Smooth hot-cold switching
- Thermostatic verification (if applicable): 38℃±1℃
- Flush system for 5 minutes before first use
(6) Troubleshooting
Issue | Possible Cause | Solution |
---|---|---|
Temperature fluctuation | Reversed piping | Check valve markings |
Cover plate misalignment | Uneven mounting box | Adjust with shims |
Weak overhead spray | Clogged filter | Clean debris |
(7) Safety & Maintenance
- Safety:
- Never exceed 1.0MPa without pressure reducer
- Ensure proper grounding (for heated models)
- Maintenance:
- Monthly nozzle cleaning (vinegar soak)
- Quarterly seal inspection
- OEM parts available from Chinese faucet factory
- Long-term storage:
- Close inlet valve
- Drain residual water
- Store hand shower separately
(Note: This guide applies to most brass concealed shower sets from Chinese faucet factories. Refer to specific manual for special models)