How to solve the problem of bathroom faucet

As a qualified shopping guide, we should not only accurately and concisely tell customers the characteristics of the products, but also have the ability to solve problems for customers. The most common problem for customers is the leakage of bathroom faucets.

I. Reasons for leaking faucets:

(1) Poor water quality  Poor water quality will cause garbage to accumulate in the valve core, which will easily cause the valve core to close tightly. (2) When the valve core is scratched during use, it is scratched due to the abrasion of foreign hard materials. For example, when the water pipe is ruptured and re-watered, the water may contain rust or sand particles, which may cause the surface of the valve core during the opening and closing process. It is scratched, cannot be sealed and leaks water. Special attention should be paid to cleaning up the impurities in the water pipe when installing the bathroom faucet. (3) Pipe connection: The water inlet hose and the main body of the sanitary faucet are leaking due to improper installation.

Second, the faucet of the bathroom faucet is tarnished or even rusted. The plating layer of the bathroom faucet plays a role of rust prevention.

However, this does not mean that the bathroom faucet will never rust without any maintenance. No matter how good a bathroom faucet, there will be many small holes on the plating layer that can't be discerned by the naked eye. The difference is that for good quality products, these small holes will be a little smaller and the hole diameter will be smaller. However, if no maintenance is performed, the daily moist gas and the corrosive gas produced by frequently used hand soap and grease will always run in from here. As time passes, the material under the plating layer will rust and leak to the surface. The method to keep the bathroom faucet shiny and rust-free for a long time is to wipe the bathroom faucet with car wax on a regular basis (such as half a month or once a month), seal the small holes on the surface of the plating layer, and prevent moisture and corrosive gases from running in. Special Note: Do not use hard objects such as steel balls to wipe bathroom faucets.

Three, the reason of the constant temperature faucet

1. The amount of hot water consumption is too small It mainly occurs to users who use gas water heaters, and it mostly occurs in summer. Due to the relatively small amount of hot water in the summer, the water heater is easy to meet, and after it is satisfied, the ignition is stopped. When the hot water is insufficient, it will ignite again. Repeatedly igniting, extinguishing, and igniting in this way results in the presence, absence, and existence of hot water supply, which causes the effluent to be suddenly cold and hot. Solution: Relatively reduce the fire and temperature of the water heater. 2. Insufficient power The matching water heater has insufficient power, and the required heat cannot be met. The solution: Replace the high-power water heater with the garbage blocked filter and the garbage blocked, resulting in a decrease in water pressure. Solution: Clear the filter at the angle valve.