Bathroom faucet is broken

Fault one: The water faucet in the bathroom faucet has a water fork or the amount of water is reduced, and there is no air bubble phenomenon.

Cause: The filter of the bubbler is fouled or clogged with debris.
Method: Remove the spout and clean the filter

Trouble two: The sprinkler has a small amount of water, and the water forks out.

Cause: Low water pressure or clogging of debris in the shower head

Method: Unscrew the shower head and take out the rubber washer with a filter in the water inlet or clean the shower top spray.

Malfunction 3: Noise on the body or piping when closing the bathroom faucet

Reasons: The water pressure in the home is too high; the faucet handle of the bathroom closes quickly; the hot and cold water pipes are poorly fixed; there are obstacles in the water inlet pipe, which causes the water pressure to change sharply.
Method: Reduce the water supply pressure (close the triangle valve small) to avoid closing the sanitary faucet quickly for re-construction, clean the pipes, and check whether the water pipes and connected objects (such as water purifiers, water heaters) have a bad connection. Zh

Fault four: The temperature adjustment is not easy, and the water temperature often changes.

Reason: The pressure difference between hot and cold water is too large, or the capacity of the water heater to raise the water temperature is not enough.

Method: Turn down the hot and cold triangle valve of the water heater (turn counterclockwise) to balance the pressure, and ensure that the temperature of the water heater can keep up with the speed

Fault five: unable to obtain higher water temperature

Cause: Insufficient power of the water heater, the position of the temperature control knob is incorrect.

Method: Adjust the temperature control knob or use a high-power water heater

Fault 6: Leakage at the connection between the hose and the bathroom faucet

Cause: Improper installation, deformed rubber ring, uneven or thin water pipe joints

Method: Replace the rubber ring and reinstall it. When installing the hose joint, do not apply excessive force, which will cause damage to the leather pad of the water pipe.

Malfunction 7: The basin faucet and kitchen faucet have a small amount of water and do not bubble.

Cause: The bubbler cannot produce bubbles due to the low water pressure.

Method: Remove the bathroom faucet and change the bubbler