How to install bathroom faucet

Posted on April 02 2022

After you purchase a shower, bathtub, wall-mounted sanitary faucet, you can choose a suitable height to bury the water pipe. The distance between the hot and cold water pipes must be 15 cm. Before installation, you must not forget to rinse the water pipe, so as not to cause the water quality to be too hard, which may cause damage to the bathroom faucet.

I. One-handle washbasin faucet

You should pay attention to the diameter of the water outlet when purchasing a single-handle basin bathroom faucet. Now most of the market is a national standard product. You should also pay attention to the height of the water inlet, 35 minutes from the sink is most suitable. When installing, be sure to choose a special angle valve, and the angle valve must be fixed to the hot and cold water pipe from the wall. When you find that there is a distance between the angle valve and the water pipe on the bathroom faucet, you can purchase a special extension pipe for the bathroom faucet at the then purchase store to connect. Remember, do not use other water pipes to connect, because if the water pressure is high, it will easily fall off and leak, causing you loss.

Second, shower, bathtub, bathroom faucet (hanging on the wall)

After you have purchased a shower, bathtub, or wall-mounted bathroom faucet, you can choose a suitable height to bury the water pipe. The distance between the hot and cold water pipes must be 15 minutes. Before installation, you must not forget to rinse the water pipe, so as not to cause the water quality to be too hard, which may cause damage to the bathroom faucet. If the elbow between the bathroom faucet and the wall joint is too long, you can cut off a part of the 4-point wire. Remember: the 6-point connected to the bathroom faucet does not seem to be cut randomly.

Third, concealed shower, bathtub bathroom faucet

After purchasing a concealed bathroom faucet, the valve core of the bathroom faucet is generally buried in the wall. Pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the spool cannot be embedded. The plastic protective cover of the valve core should not be easily removed during embedding, so as to prevent the valve core from being damaged by cement and other chores during the embedding. In addition, you should pay attention to the up, down, left and right directions of the valve core when embedding the valve core, so as not to bury the valve core incorrectly.

Fourth, constant temperature bathroom faucet

Before installing the thermostatic bathroom faucet, please check whether the water pipe is hot and cold right, and remember not to connect the hot and cold water pipes incorrectly, so as to prevent the bathroom faucet from working properly. Gas-fired and solar water heaters cannot use thermostatic sanitary faucets because the water pressure is too low. Do not forget to install hot and cold water filters when installing thermostatic bathroom faucets.

V. Showers

After you have installed the shower, bathtub and bathroom faucets, don't forget the filter in the shower tube when you need to install the shower. When installing the shower, the water pressure must not be too high, generally 3 kg is the best and cannot exceed 5 kg. If the water pressure is too high, the water flow limiter in the faucet of the bathroom faucet can also be opened to reduce the water pressure and achieve the effect of water saving.