Angle Valve Self Sealing Installation Guide

The angle valve self sealing is a crucial component widely used in household and industrial pipeline systems. Produced by Fabbriche di rubinetti cinesi, the self-sealing angle valve is renowned for its high sealing performance, typically made of brass or stainless steel, and equipped with wear-resistant sealing gaskets inside. This design allows the angle valve to achieve automatic sealing under pipeline water pressure, effectively reducing the risk of leakage and making it suitable for long-term stable use.

Installation Steps

1. Preparation: Before installing the angle valve self sealing, ensure that the pipeline system is shut off and there is no residual water pressure inside the pipeline. Prepare the necessary tools, such as wrenches, screwdrivers, and sealant.
2. Inspect the Angle Valve: Before installation, carefully inspect all parts of the angle valve self sealing to ensure there is no damage or defects. Pay special attention to the internal sealing gasket, ensuring it is intact.
3. Install the Angle Valve: Apply an appropriate amount of sealant to the threaded part of the angle valve self sealing, then screw it into the pipeline interface. Use a wrench to tighten it properly, but avoid over-tightening to prevent damaging the threads.
4. Connect the Pipeline: Connect the other end of the angle valve self sealing to the water pipe, also using sealant and a wrench for fixation. Ensure the connection is tight and leak-free.
5. Test the Seal: After installation, turn on the water supply to the pipeline system and check for any leaks at the connection points of the angle valve self sealing. If there is a leak, re-tighten or replace the sealing gasket.
6. Regular Inspection: Although the angle valve self sealing requires minimal maintenance, it is recommended to regularly inspect the internal sealing gasket for wear. If aging or damage is found, replace it promptly to ensure the long-term stable operation of the system.

Conclusione

The angle valve self sealing produced by Fabbriche di rubinetti cinesi, with its high sealing performance and durability, is an ideal choice for pipeline systems. Through proper installation and regular maintenance, the angle valve self sealing can effectively reduce the risk of leakage and ensure the long-term stable operation of the system.